menu "ESP serial flasher" config SERIAL_FLASHER_MD5_ENABLED bool "Enable MD5 check" default y help Select this option to enable MD5 hashsum check after flashing. choice SERIAL_FLASHER_INTERFACE prompt "Hardware interface to use for firmware download" default SERIAL_FLASHER_INTERFACE_UART help esp-serial-flasher can work with UART and SPI interfaces. config SERIAL_FLASHER_INTERFACE_UART bool "UART" config SERIAL_FLASHER_INTERFACE_SPI bool "SPI (Only supports downloading to RAM)" config SERIAL_FLASHER_INTERFACE_USB bool "USB" config SERIAL_FLASHER_INTERFACE_SDIO bool "SDIO (Experimental, Only supports downloading to RAM)" endchoice config SERIAL_FLASHER_RESET_HOLD_TIME_MS int "Time for which the reset pin is asserted when doing a hard reset" default 100 config SERIAL_FLASHER_BOOT_HOLD_TIME_MS int "Time for which the boot pin is asserted when doing a hard reset" default 50 config SERIAL_FLASHER_DEBUG_TRACE bool "Enable debug tracing output (only transfer data tracing is supported at the time)" default n config SERIAL_FLASHER_WRITE_BLOCK_RETRIES int "Number of retries when writing blocks either to target flash or RAM" default 3 config SERIAL_FLASHER_RESET_INVERT bool "Invert reset signal" default n depends on SERIAL_FLASHER_INTERFACE_UART help Enable this option if there is an inverting connection between the output of the serial-flasher and the reset pin of the ESP chip. config SERIAL_FLASHER_BOOT_INVERT bool "Invert boot signal" default n depends on SERIAL_FLASHER_INTERFACE_UART help Enable this option if there is an inverting connection between the output of the serial-flasher and the boot pin of the ESP chip. endmenu menu "I2C Master" config I2C_MASTER_SCL int "SCL GPIO Num" default 22 help GPIO number for I2C Master clock line. config I2C_MASTER_SDA int "SDA GPIO Num" default 21 help GPIO number for I2C Master data line. config I2C_MASTER_PORT_NUM int "Port Number" default 1 help Port number for I2C Master device. config I2C_MASTER_FREQUENCY int "Master Frequency" default 100000 help I2C Speed of Master device. config AXPxxx_INTERRUPT_PIN int "Interrupt Pin" default 35 help axp202,192,173 interrupt pin. endmenu